ALISHA MKE-Mini Package For 3D Printed Iron Man Costume/Cosplay

Description: A.L.I.S.H.A. MKE-Mini ***The Board needs to be powered with a USB powerbank, Operating voltage is 5v (2.1A), DO NOT USE ?AA? OR ?AAA? BATTERY PACK, THEY CAN DAMAGE THE BOARD*** A.L.I.S.H.A - Arduino based LED & Integrated Servo Helmet Actuator is a simple to install Arduino ESP32-C3 shield module that allows DIY people to easily motorize and light up their favorite 3D printed Iron Man helmet or any other helmets (i.e. Batman, Gray Fox, etc.). Drives up to 3 MG90S servo motors (recommended), 2 LEDs for eyes (PWM), 1 button/switch, and an expansion port for additional features. Each LED port has a current limiting resistor. Includes: Board with JST-XH connections Arduino compatible ESP32-C3 processor Male JST-HX pin headers for easy jumper wire connection - 3x3 pin, 2x2 pin *** USB cable, Servos, and LED eyes not included. ***PENELOPE - Powerbank Keep Alive Load Pulser (separate add-on board)*** This USB Power Bank Keep Alive version 4.0 is a simple to install module that allows DIY people to easily keep their USB power bank from deactivating at the most inconvenient times during Cosplay or fighting villains! Includes: Board with USB connections Board Size: 28mm x 35mm USB cables not included The power input connector is a USB-Mini (same as on an Arduino Nano) & the power output is a USB-A (Standard Size) ***Full documentation, instructions and code can be found on the Thingiverse Crash Works 3D page and Crash Works 3D GitHub Page found in our LinkTree: https://linktr.ee/crashworks3d***

Price: 34.99 USD

Location: Plainfield, New Jersey

End Time: 2024-08-21T21:34:54.000Z

Shipping Cost: N/A USD