Belt Grinder 2x72 wheel set for knife grinders

Description: FRIENDS, BEWARE OF THE JUNK WHEELS FROM CHINA, TURKEY & POLAND THAT ARE FLOODING THE MARKET. THEY MAKE NICE PICTURES & THE SAME SELLERS MAKE DOZENS OF LISTINGS BUT THEIR PRODUCTS ARE VERY BAD. THEY USE THE WORST GRADE OF ALUMINUM, THE SAME STUFF THAT WINDOW FRAMES ARE MADE OF SO THEIR WHEELS WEAR OUT PREMATURELY. (BE ESPECIALLY CAREFUL OF A CHINESE BRAND CALLED "VEVOR", THE CROWNS WEAR OFF THEIR WHEELS IN NO TIME & THEY PUT A KNURL ON THEIR DRIVE WHEELS WHICH CHEW THROUGH BELTS). SO IF YOU WANT A QUALITY PRODUCT ON YOUR GRINDER BUILD, LOOK NO FURTHER. OUR WHEELS ARE SLIGHTLY MORE EXPENSIVE BECAUSE THEY ARE TOP QUALITY & MADE RIGHT HERE IN THE US WITH THE BEST MATERIALS TO THE HIGHEST STANDARDS. BUY WITH CONFIDENCE! This set comes with a 5/8" bore drive wheel, if you require a 3/4" or 7/8" or 19mm or 24mm bore drive wheel leave a note on the checkout page saying which one you need & we'll send that with the set. MADE WITH PRIDE IN THE USA! A set of: Two, 2" diameter precision turned aluminum idler wheels with THREE sealed bearings in each, 2-1/4" WIDE (CHEAP WHEELS ARE 2" WIDE). Standoff spacers included One, 3" diameter precision turned aluminum tracking wheel with THREE sealed bearings. The tracking wheel is 2-1/4" wide, 3" in diameter & CROWNED (no sharp v) to ensure accurate belt tracking. BE WEARY OF CHEAP HAND TURNED TRACKING WHEELS, THEY HAVE A SHARP V INSTEAD OF A CROWN. THIS V IS DUE TO MANUAL MACHINING RESTRICTIONS, THEY CAN'T MACHINE A CROWN ON A HAND LATHE. THE V IS HARD ON BELTS, UNTIL IT WEARS AWAY PREMATURELY, RENDERING THE WHEEL USELESS. THE HAND TURNED WHEELS ARE ALSO ONLY 2" WIDE. (4" tracking wheels offer no advantage, they're heavy & soak up energy unnecessarily). Standoff spacer included. One, 4" diameter precision turned aluminum drive wheel. The drive wheel is 4" in diameter & crowned to ensure accurate belt tracking. The face of the drive wheel is 2-1/4". The set screw (included) is 1/4-20 & 1/2" long. Please note that the bore of this drive wheel is 5/8", see note above if you need a drive wheel with 3/4" or 7/8" bore. The wheel is broached all the way through, cheap drive wheels are not broached all the way through. The wheel is lightened. For DIY style grinders like GIB, EERF, NO WELD etc. Also work well on any professionally manufactured 2x72" belt grinder. The wheels are 2-1/4" face width to comfortably accept any commercial 2" wide grinding belt. Bore of the bearings is 1/2" so you can use any 1/2" diameter bolt as an axle. The bearings are easily replaceable when worn. We use these wheels on the top quality grinders & flat plattens that we manufacture & our design has been thoroughly tested to withstand even the harshest knifemaking environments! We do not paint, polish or anodize our wheels as this just adds cost & comes off basically on your first use. Please also have a look at our other listings, visit our Ebay store & search OriginBladeMaker on Youtube for some other fun stuff. We do not ship this set in a padded envelope, it's too heavy & may become damaged, we only ship the set properly bubble wrapped & shipped in a box, hence the slightly higher shipping fees.

Price: 96.95 USD

Location: Hillsboro, Oregon

End Time: 2024-08-02T21:07:26.000Z

Shipping Cost: 15.5 USD