Description: Helix P ONE MK2 High-Res Mono Amplifier by Audiotec Fischer , digital input HELIX P ONE MK2Raw power – Total controlLoads of power and tremendous stability: Our new P ONE MK2 is the ideal performance package for any subwoofer configuration. With up to 1,800 Watts RMS @ 1 Ohm, the upgrade to our powerful mono amplifier is going to rev up any woofer while always maintaining full control due to its enormous damping factor. High-Res Audio and a fully digital signal chainThe P ONE MK2 is designed for more than just driving subwoofers. With its particularly wide frequency range up to 40 kHz and excellent signal-to-noise ratio as well as the extremely low THD, you can expect nothing less than High-Res sound quality, making it well suited for the use as a fullrange amplifier.Due to the newly integrated optical digital input, an interference-free and ground-isolated signal transmission in the best possible quality all the way into the amplifier is now possible. The input receives signals up to a 96 kHz sampling rate lossless via light conductor and converts them back to the analog level via a cutting-edge 32-Bit BurrBrown D/A converter. Thus, the P ONE MK2 can be perfectly combined with one of our DSP amplifiers with optical digital output, for example the HELIX P SIX DSP ULTIMATE. Extremely high power density with particularly compact dimensionsIn terms of power density, the P ONE MK2 plays in a different league. No other HELIX amplifier includes so much power into such a compact package. This unique power-to-size ratio enabled by our extraordinary efficient Class D concept, which goes hand in hand with exceptionally low heat dissipation. FeaturesHigh performance Class D mono amplifier with up to 1,800 Watts RMS @ 1 Ohm – a perfect match for all 2 x 2 Ohms subwoofers connected in parallelHigh-res capability thanks to an extended audio frequency response of over 40 kHz for unsurpassed sound qualityExtremely high efficiency and low heat dissipation with minimal dimensionsHigh damping factor for maximum speaker controlDigital, optical signal input in SPDIF format including SPDIF Direct In switch for routing the digital input signal directly and losslessly to the power stageBurrBrown D/A signal converter of the latest generation with a resolution of 32 BitSwitchable Subsonic filterRegulated power supply with Start-Stop capability for extremely stable output power even during voltage dropsSMD (Surface Mounted Device) manufacturing technology combines minimum space requirement with maximum reliabilityInput Mode switch to adapt the amplifier to the input signalPerfectly combinable with HELIX P SIX DSP ULTIMATE amplifierSpecial features:Fully digitalThanks to its digital input, the HELIX P ONE MK2 enables a completely interference-free and ground-isolated signal transmission in best possible quality right into the amplifier. The input can handle digital audio signals up to a sampling rate of 96 kHz losslessly via fiber optics cable and converts them back to the analog level via a cutting-edge BurrBrown D/A converter.But that's not all– in order to get the very last bit of performance out of the amplifier and avoid even the slightest influence of its input stage, the SPDIF Direct In function can be used to route the audio signal directly and without any detours to the output stages of the amplifier. High-Resolution audioThe extremely wide frequency range up to 40 kHz enables lossless audio reproduction of High-Resolution audio content to provide the best possible sound in studio quality. Signal converters with a native resolution of 32 BitThe HELIX P ONE MK2 uses for the optical input a high-class D/A signal converter of the latest generation with a native resolution of 32 Bit instead of the common 24 Bit. The result is an unprecedented precision in signal conversion that especially optimizes the sound quality at lower signal levels. Start-Stop capabilityThe switched power supply of the HELIX P ONE MK2 assures operation even if the battery’s voltage drops down to 6 Volts during engine crank. Technical dataPower RMS ≤ 1% THD+N - @ 4 Ohms1 x 500 Watts - @ 2 Ohms1 x 880 Watts - @ 1 Ohm1 x 1,500 Watts - bridged @ 4 Ohms- - bridged @ 2 Ohms- Max. output power per channel*Up to 1.800 Watts RMS @ 1 OhmsAmplifier technologyClass DInputs2 x RCA / Cinch1 x Remote In1 x Optical SPDIF (28 - 96 kHz) Input sensitivityRCA / Cinch 0.5 - 8 VoltsInput impedance RCA / Cinch20 kOhmsInput impedance highlevel-Outputs1 x Speaker outputOutput voltage RCA / Cinch- Signal converter for digital inputBurrBrown 32 Bit DA converterFrequency response21 Hz - 40,000 HzBass boost-Highpass-Lowpass-Bandpass-Subsonic21 Hz Phase- Slope high- / lowpass-Slope subsonic / lowpassButterworth 48 dB/Oct.Signal-to-noise ratio digital input110 dB (A-weighted)Signal-to-noise ratio analog input110 dB (A-weighted)Distortion (THD)< 0.01 %Damping factor> 450Operating voltage10.5 - 17 Volts (max. 5 sec. down to 6 Volts)Idle current1500 mAFuse4 x 30 A LP-Mini-fuse (APS)Power ratingDC 12 V ⎓ 160 A max.Additional featuresInput mode switch, SPDIF Direct In switch, Start-Stop capabilityDimensions (H x W x D)50 x 260 x 190 mm /1.97 x 10.24 x 7.48”* In typical applications as subwoofer amplifier Scope of delivery1 x Amplifier HELIX P ONE MK21 x Instruction manual
Price: 700 GBP
Location: Blaydon
End Time: 2024-02-07T10:46:58.000Z
Shipping Cost: 66.4 GBP
Product Images
Item Specifics
Return postage will be paid by: Buyer
Returns Accepted: Returns Accepted
After receiving the item, your buyer should cancel the purchase within: 30 days
Signal/Noise Ratio: 110db
Brand: Helix
Manufacturer Part Number: P ONE MK2
Country/Region of Manufacture: Germany
RMS Power: 1500w
Impedance: 1 Ω
Channels: 1
Colour: Black