IMAX B6AC 80W LCD Digital Display Battery Balance Charger for Lipo LiFe NiMh

Description: IMAX B6 LCD Screen Digital RC Lipo NiMH NiCd LiFe Pb Battery Balance Charger Discharger MAX B6 is the new intelligent multifunction charger which can charge and discharge for Lion, LiPo, LiFe , Pb, NiCd and NiMH batteries. Its all-powerful in a way Specifications Operation voltage range : DC 11.0 ~ 18.0 Volt or AC 100V ~ 240V 50/60Hz Circuit power : AC to DC adaptor (DC 11.0 ~ 18.0V / 5A) Max. charge power 80W Max. discharge power 5W Charge current range : 80w: 0.1~6.0A 50w :0.1-5.0A Discharge current range : 80W:0.1~2.0A 50W:0.1-1A Current drain for balancing Li-Po : 300mAh/cell NiCd / NiMH battery cell count : 1~15 cell Li-Ion / Polymer cell count : 1~6 series Pb battery voltage : 2V~20V Weight : 546g (Net Weight) Dimensions : 136 x 141*34mm Package weight: 778g XT60/T Plug Expansion board: PRODUCT DESCRIPTION:6 groups of the same type of charging, the same number of 2-6S battery pack parallel balanced charging can simultaneously support 6 groups of 2S, or 6 groups or 6 groups of 4S, or 6 groups of 5S, or 6 groups of 6S parallel balanced charging.Super short circuit protection (40A wire at the top makes charging safer)Super expansion function (can parallel three charging plates at the same time, you can balance 18 batteries at the same time) 【 Detailed parameters 】 1. The balanced output line adopts 20AWG multi-strand silicone wire. 2. The main output line adopts 14AWG multi-strand high quality silicone wire. 3. Equipped with safety protection T-insert silicone cap. 4. Thickened PCB copper foil to allow safe passage of 30 amp charging current. The product is suitable for parallel 1 to 6 batteries (including LiPo,LiFe,Lion) with balanced charging. Product features are as follows: 1. With short-circuit protection function 2. Support 3 sets and charging board combination (can simultaneously charge 18 groups of batteries of the same nature) 3.20Z super thick copper moor sustainable current 80A 4. It can avoid overcharging of a single battery, so it can improve the balance efficiency, and the later stage of the balance charge cycle is greatly shortened. 5. Charging time is only the charging time of a single battery, so charging time can be saved. 6. Avoid repeated battery replacement. Use steps: 1. Connect both ends of the balance cable to the balance terminals of the balance charger and the balance charging board respectively, as shown in the figure 2. Connect the power terminal of the balance charging board to the output terminal of the balance charger 3. Connect the battery to the panel. First insert the balance head and then connect it to the battery output. Set the charging voltage (even for individual batteries) and the current, which is set as follows: I=i1+i2+i3+… _in(n≤6) I:Total Current. I: total current I:the charge current of every battery. I: The charge current of every battery n: the quantity of barrery. The total number of batteries Note: If the maximum output current of your balanced battery is less than the total current "I", set the charger current to the maximum. The maximum current of the balanced charging board is 80A. The voltage of the battery must be the same when charging, and the capacity and discharge rate can be set arbitrarily. After several balances, the voltage will be more balanced and the pressure difference will be smaller. Warning: If you need to charge less than 6 battery packs, place the housing on the T-plug or any other plug currently in use to avoid an accident. When charging, each T-plug is charged. Based on the different balance heads currently available on the market, there are four types of balance charging boards: JST-XH, THUNDER POWER(TP), HYPERION(HP) and EH(KOkam), depending on your battery you can choose one of these, but we usually use the JST-XH. The function and principle of these four types of charging boards are the same. If the plug of your battery pack is XT60, JST, etc., you can purchase the type of charging pad you need. In addition to LiPo batteries, the product can also be used in LiFe and Li-Ion batteries. Package: Imax B6AC charger*1 Connecting cable *6 Manual*1 Power cord *1 (US Plug, EU Plug, UK Plug, AU Plug) Optional Power adapter *1 Or Expansion board *1（XT60 or T Plug）Optional

Price: 11.99 USD

Location: Shenzhen

End Time: 2024-08-26T07:44:09.000Z

Shipping Cost: 0 USD