Single Shot Adapter - .22 Caliber Air Venturi Avenger

Description: For sale is a custom designed Single Shot Adapter / Tray to fit the factory Air Venturi Avenger Rifle and Bullpup PCP Air Guns. These work great for bench-rest shooting and will fit on either side of the rifle to suit your preference. When shooting single shot, this will ensure pellets are seated in the correct direction. Stainless steel hardware / nylock nut and steel 2.5mm hex wrench included FREE S&H in the USA. This swing-open single shot adapter fits .22 caliber rifles only. These are shipped disassembled to prevent shipping damage. These are 3D printed in the USA, using either ABS-like resin in dark grey or FDM printed using ABS in black, yellow, or green. My preference is the dark grey resin printed model as it has a much better fit and finish. The FDM printed adapters in ABS fit and work just the same. These plastics will not warp when exposed to outdoor heat, or left in the sun. The Mount has a deep black slightly textured surface. Please note: Do not expect the pellet to fit snug; the hole needs to be just large enough to allow the o-rings on the pellet-probe to fit through and properly seat the pellet in the barrel, which means the pellet fits loosely. These have been tested on both a wood stocked rifle and the bullpup rifle with no issues. If your scope rings are low, you may need to remove the scope to install the Single Shot Adapter. Assembly:1 - Insert the M3 nylock nut on the one side with the hex-shaped recess,.2 - Install the center pellet holder into the main body with the flip-tab facing up.3 - Insert the 20mm M3 screw through the body and center piece and using the provided hex wrench, tighten the screw while holding the hex nut in the recess. Tighten the screw snugly until the center piece does not rotate on its own, to seat the screw and nut, then back it off until the center piece rotates easily. - Max torque = 12 inch-lbs. DO NOT OVER-TIGHTEN. I recommend lightly lubing the o-rings on the pellet-probe and the bore-hole of the Single Shot Adapter using your preferred synthetic oil or grease that is PCP air gun friendly. DONE - Enjoy your new Single Shot Adapter on your Air Venturi Avenger air rifle. Exclusively designed and 3D printed in the USA Made with ABS plastic / ABS-like Extra-Tough polymer resinSimple yet solid long lasting designThese are designed and 3D printed in the USA, by Crooks USA The rifle, scope, stand, bi-pod, and all other parts & accessories are NOT included. MADE IN THE USA THESE ARE PARTS ONLY. THEY ARE NOT FOR ILLEGAL USE.THESE DO NOT ADD TO OR ALTER ANY FIREARM IN ANY WAY. PLEASE FOLLOW ALL FEDERAL, STATE & LOCAL LAWS.FOLLOW ALL FIREARM SAFETY RULES.

Price: 18 USD

Location: Rosemead, California

End Time: 2024-04-05T00:37:40.000Z

Shipping Cost: 0 USD