Description: This is a listing for a pazi88 version of STM32F407VGT6 MCU on an Arduino Mega2560 socket. Except the MCU has been replaced with VGT6 version to allow rusEFI to work. This is meant to run rusEFI or Speeduino engine management system. MEGA100 rusEFI firmware, and the STM32 port of Speeduino firmware. But if you just need to update a Mega2560 based system to STM32, this might work as well. The motivation behind this is to be able to retrofit Speeduino boards with either Speeduino firmware on stm32, with additional CANbus features, or be able to switch to rusEFI while keeping the same hardware. This has onboard CANBUS PHY connected to PD1/PD0 ( can0 ALT_2 in stm32 world) for communicating with peripherals over canbus. This board has 16 voltage dividers (470/1k) to scale 5v signals down to 3.3v, as well as opamps for those 16 analog inputs. This board has local SPI flash installed. This board DOES have buffers between Mega socket and CPU pins There are 7 pins not connected. The board comes with Mega pin sockets installed. This board has USB-B port for flashing using DFU. There is a spot for ST-LINK header to flash that way as well. There are two buttons, one for RESET and one for BOOT0. The pinout and location of buffers for this board is as follows:
Price: 45 USD
Location: Freehold, New Jersey
End Time: 2024-10-13T16:42:07.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Brand: stm32
Series: STM32
Type: General Embedded Development Board
Program Memory Type: Flash
Unit Type: Unit
RAM Size: 1MB
Features: can bus, sd card
Item Length: 105mm
Country/Region of Manufacture: China
Unit Quantity: 1
Item Width: 55mm
Core: ARM
